TripleCautionMW
Plastic
- Joined
- Jun 21, 2018
Hi Guys, I’ve done some digging around and can’t seem to find any posts on successfully clearing a “6000 EMERGENCY STOP” error on a Siemens 810 controlled CHNC. I just got this lathe powered up, fluids topped off and air run to the machine. Upon initial power up I attempted to reference the machine and no luck. Under my NC Alarm page I have the “6000 EMERGENCY STOP” error. Under the PLC Alarm page I have the following errors;
6000 EMERGENCY STOP
6002 AXES NOT ENABLED
6011 AXIS DRIVE FAULT
6012 SPINDLE DRIVE FAULT
6004 COLLET LOSS OF AIR
6001 LOSS OF MAIN AIR PRESSURE
6016 LUBE SYSTEM FAILURE
This machine last ran about a year ago and has been moved twice since then. Looking for anyone that may have a clue about these machines as the manual doesn’t reference any 6000 series error codes for troubleshooting. Thanks in advance.
-Jon
6000 EMERGENCY STOP
6002 AXES NOT ENABLED
6011 AXIS DRIVE FAULT
6012 SPINDLE DRIVE FAULT
6004 COLLET LOSS OF AIR
6001 LOSS OF MAIN AIR PRESSURE
6016 LUBE SYSTEM FAILURE
This machine last ran about a year ago and has been moved twice since then. Looking for anyone that may have a clue about these machines as the manual doesn’t reference any 6000 series error codes for troubleshooting. Thanks in advance.
-Jon