Can someone explain how their start/e-stop switch used on the later style speed control panels as shown in the photo functions? Is it a momentary push/pull or maintained? The part number of the switch, PTY4211, is shown as a 3-position switch. Not sure what of the third position. I’ll explain why I’m asking. An earlier post of mine, I asked about relettering the speed panel. My newly acquired lathe looks as if someone sprayed a cleaner on it. Painted is streaked and every tag (High/low, Fwd/Rev, etc) is bare aluminum. The black has been washed off including the speeds on the speed indicator panel. While I went back an forth with Hardinge via email on price and availability of the panel and tags, I looked into making new ones. Well, it turns out, the tags and panel are still available. Not cheap, $90 for the panel, but easier then spending hours making a new one. One catch, only the later style is available. Mine is the earlier style with separate “Faster” and “Slower” button with no stop. So that’s what brings me to me e-stop questions. I will appreciate it if someone can answer my question.