Jeremiah L
Plastic
- Joined
- Jul 11, 2017
Any tips on how to get the steel ball out out of the hand wheel clutch? The ball bearing looks like it is impacted into the hole and won't come out. The ball and the hole look clean, the ball is just lodged into the hole.
Ive tried shaking the feed reverse knob back and fourth.
Ive tried putting a air hose over the reverse clutch rod and blasting it with compressed air.
Ive tried to extricate it with a strong magnet.
Ive tried blasting it with WD40 and PB blaster.
I used a needle to try to dig out and burrs or debris from the hole...
Is there a way to get the shaft out without taking off the hand wheel clutch?
Ive tried shaking the feed reverse knob back and fourth.
Ive tried putting a air hose over the reverse clutch rod and blasting it with compressed air.
Ive tried to extricate it with a strong magnet.
Ive tried blasting it with WD40 and PB blaster.
I used a needle to try to dig out and burrs or debris from the hole...
Is there a way to get the shaft out without taking off the hand wheel clutch?