I am in a machine desert so the chance to pick up a knee mill is very uncommon, but I am looking at this. I see the spindle brake is on in this video but there is a lot of noise. Is that normal? (could be the video method?) If I am not mistaken this is a low range test too so the noise has me concerned.
If this is an issue here is it difficult to remedy? I know I don't have a lot to bring to the table here except questions but is there anything for me to be thinking about when I consider this machine?
Bridgeport Series I 2 HP Table Milling Machine w/ US Electrical Motors 7347 - Oahu Auctions
If this is an issue here is it difficult to remedy? I know I don't have a lot to bring to the table here except questions but is there anything for me to be thinking about when I consider this machine?
Bridgeport Series I 2 HP Table Milling Machine w/ US Electrical Motors 7347 - Oahu Auctions