woodworkerJB
Aluminum
- Joined
- Sep 27, 2011
- Location
- Colorado, USA
I have an older style 6f power feed with a bad board. It is the version that had the controls on the table but the board was encased in a box mounted to the side of the mill. This board is not the same design as the newer 6f where the board was mounted on the table below the motor. I would like to try my hand at rebuilding this board. Does anyone have a copy of the board schematic for this version? The SECO part number is f6120 there is another number above the seco name D28651 j and an assembly number D28665