I think i did okay buying an old Mews rotary table and 4 jaw geared chuck
I couldn't find much info online but maybe someone could help with a couple questions i have
I cant figure out how to remove the worm gear assembly that turns the table?
The machined surface the table rides on has an oil groove. This is fed from oil cup on the side. The oil cup is at the same level as the machined surface. How does the oil get to the contact surface?
There is a spring loaded ball on the table surface that is used to oil the centre bearing spindle. Do i need a special tool to get the oil in there?
Thank you
I couldn't find much info online but maybe someone could help with a couple questions i have
I cant figure out how to remove the worm gear assembly that turns the table?
The machined surface the table rides on has an oil groove. This is fed from oil cup on the side. The oil cup is at the same level as the machined surface. How does the oil get to the contact surface?
There is a spring loaded ball on the table surface that is used to oil the centre bearing spindle. Do i need a special tool to get the oil in there?
Thank you