What's new
What's new

turret lathe tooling, large lot for sale

solidworkscadman

Hot Rolled
Joined
Mar 10, 2011
Location
MASS
I have a large lot of tooling id be willing to let go,

box turning, knurling , many different turret tools to choose from

20180730_113947.jpg

89238425_10163390004830492_7283413825548713984_o.jpg

86992326_10163390004660492_2702073301550759936_o.jpg

I would be willing to ship, also for sale local in beverly ma

dan-
 
Practical Machinist has a provision for selling stuff. You got the winning stuff for a turret lathe. So many I see today put drill chucks on their HC and small turret lathes. V block holders are the only thing I would use. The holders look to be Brooksfield used them for years then decided I liked the Somma ones better.
You might make a list of sizes and brands and such if you run the real ad in the classified.
 
If you move this to the classified section, Please post a link here,

List the items by shank size 5/8", 3/4 etc.

Looking for a couple or 3 Brookfield DA-10 holders
Floating reamer holders,
a fine adjust knee tool DSM-1?
A taper attachment for the DSM-59
etc.

Bill
 
If they are 5/8 shank, how much for:

1) the three roller center rest in the middle photo,

2) the adjustable knee tool in the middle photo (upper right-ish)

3) and the smallest roller box tool you have (probably at least one in there)

Thanks.
 
If they are 5/8 shank, how much for:

1) the three roller center rest in the middle photo,

2) the adjustable knee tool in the middle photo (upper right-ish)

3) and the smallest roller box tool you have (probably at least one in there)

Thanks.

I will reply back with a detailed discription
 
If it's any help, I need a box tool, 1" shank with enough capacity to rough a 1" bar towards 1/2" finish diameter. Interested in 2 if you got 'em. Contact me by PM, too, if you like. Email throught the control panel is, unfortunately, unreliable.

Tks!
 
I need the following with a shank size of 5/8":

3 to 4 Brookfield DA-10 holders
If you have the baby one that is smaller than 1/2" capacity, I am interested.

Floating reamer holders, Is that one behind the T4 knee tool?
What do you have?

1 or 2 fine adjust knee tool DSM-1?

A taper attachment for the DSM-59 mine is a model D but I could use the older unmarked version.
I need a second one because I am tooling up a machine 30 miles from my shop.

Bill

Post better pictures here and PM me with pricing.

Thanks,
Bill
 
Classification by shank size would indeed be very useful. I have interest in 1" shanks for initial convenience on my machine, but further interest in the rest with more details supplied.
 
Classification by shank size would indeed be very useful. I have interest in 1" shanks for initial convenience on my machine, but further interest in the rest with more details supplied.

The pictures and the fact that he posted in the Hardinge forum make me think he has only 5/8" shank tools.

I have a lot of 1" and 3/4" shank turret tools if anyone has specific requirements. I have not used the turret on my Clausing for about thirty years. I did send a PM to the person who asked about 1" roller box tools, since I have one NOS Boyar Schultz 2RB and two 2RTC models.

Larry
 








 
Back
Top