I have a vmc 1000 2500b control,with a door switch problem, all inputs to the control are good, but control still allows machine operation in all states.
is there a user parameter to control switching this function on and off
I ran a VMC 1000 several years back. When the machine was delivered the "male" half of the switch was just stuck into the other half that was mounted. Basically mechanically bypassing the switch. The "male" half was never removed to mount on the other door.
the machine is turning the signal to the control on and off but the control is not out putting the inhibit signal.
either the plc is corrupt or there is a user parameters written in to the ladder that I do not know of.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.