markp
Hot Rolled
- Joined
- Oct 7, 2006
- Location
- Petaluma CA 94952
Im trying to test a post processor for my DMG DMU103V with 840D control. I can run a few lines then any axis movement causes a 10720 error. This a software limit error somehow related to the zero offsets. The part WCS is in the middle of the table so theres no way its close to any hardware or software limit. Any suggestions on how to clear this type of error? Is it somehow related to some global Machine coordinate?
Heres a pic of my workpiece limits. Seems kind of large. I didnt set these except maybe by accident. Seems like plenty of room.
Heres a pic of my workpiece limits. Seems kind of large. I didnt set these except maybe by accident. Seems like plenty of room.