I am fairly new to machining (and MasterCam) and I ran across 2 parts that I haven't been able to figure out yet.
I need to make a part out of White Delrin that has #70 GPI I.D. threads. What tool/insert would I need to create the thread?
Then I also need to machine a part out of Ultem 1000 that has 1 1/2 - 11.5 NPT threads on the O.D. How do I program NPT threads in MasterCam 2020 and how much different is it to program than regular threads? I will be using a solid model that an engineer created in Inventor, by the way.
Any and all advice would be helpful! Thank you!!!
I need to make a part out of White Delrin that has #70 GPI I.D. threads. What tool/insert would I need to create the thread?
Then I also need to machine a part out of Ultem 1000 that has 1 1/2 - 11.5 NPT threads on the O.D. How do I program NPT threads in MasterCam 2020 and how much different is it to program than regular threads? I will be using a solid model that an engineer created in Inventor, by the way.
Any and all advice would be helpful! Thank you!!!