AndrewOrme
Plastic
- Joined
- Jul 27, 2020
Hello all, I am a mechanical engineer with lots of 3D design experience but I lack on the CAM side of things. I am using Fusion 360 to create a tool path for a mold. Tools range from between .007 and .035 flat end mill and ball end mill so it is a very small part. I'm using 3D adaptive for the tool path.
When creating the tool paths the tool retracts many many times. See yellow lines on attached. I have the LINKING at minimum retraction and STAY DOWN LEVEL at most. Any solutions/suggestions would be great.
Thanks
When creating the tool paths the tool retracts many many times. See yellow lines on attached. I have the LINKING at minimum retraction and STAY DOWN LEVEL at most. Any solutions/suggestions would be great.
Thanks
Last edited: