Cole2534
Diamond
- Joined
- Sep 10, 2010
- Location
- Oklahoma City, OK
Without reason, I'll find that Fusion360 has added a small line to a line I've sketched and it's infuriating. Has this happened to anyone else? If so what's the solution?
Imagine- you draw a line, sketch it length say 6.5" but it doesn't line up with other features like it should. Then you mouse over the line and find there's a small segment at the beginning that you didn't tell it to execute and your correct line has begun at that segment's end rather than the point you intended.
It just did it again. The blue segment in the pic is not something I sketched and it should not be there.
Imagine- you draw a line, sketch it length say 6.5" but it doesn't line up with other features like it should. Then you mouse over the line and find there's a small segment at the beginning that you didn't tell it to execute and your correct line has begun at that segment's end rather than the point you intended.
It just did it again. The blue segment in the pic is not something I sketched and it should not be there.