Djstorm100
Cast Iron
- Joined
- Jul 26, 2014
- Location
- Richmond
How has your experience been with Hurco? Looking at a VMX32 I'm looking heavily at a Doosan 4500s but I need to start making a plan B and C in case the Doosan dealer deal falls through. Doosan Dealer doesn't give me the warm and fuzzy. Back up plan is Haas... I know I know, don't shoot me.
I'm trying to future proof with whatever I get. The Hurco dealer, I'm not worried about support/ service. A good friends of mine is good friends with a few of the guys at the Hurco dealer.
I cut mostly brass and alum. However I have a few products in the design that will benefit from being made out of 303/304 SS in stead of alum. Again future proofing, I do job work shop as well and your basic steels I would like to cut efficiently as possible. I understand there's a lot of unknown variables in that respect.
I'm trying to future proof with whatever I get. The Hurco dealer, I'm not worried about support/ service. A good friends of mine is good friends with a few of the guys at the Hurco dealer.
I cut mostly brass and alum. However I have a few products in the design that will benefit from being made out of 303/304 SS in stead of alum. Again future proofing, I do job work shop as well and your basic steels I would like to cut efficiently as possible. I understand there's a lot of unknown variables in that respect.