Solar1971
Cast Iron
- Joined
- Feb 18, 2014
- Location
- California
Hey guys.
I'm using windows 10 and MasterCAM X5
When i'm in the Drawing screen and i'm getting ready to make a path...
MasterCAM will just lockup for about 5 seconds. Then it'll work ok again for about 10 seconds.
Then Lock up again for 5 seconds, then unlock ... and so on, and so on...
Does anyone else have this issue?
And if so, does anyone know the cause?
I have 8 gigs of RAM BTW.
Thanks
I'm using windows 10 and MasterCAM X5
When i'm in the Drawing screen and i'm getting ready to make a path...
MasterCAM will just lockup for about 5 seconds. Then it'll work ok again for about 10 seconds.
Then Lock up again for 5 seconds, then unlock ... and so on, and so on...
Does anyone else have this issue?
And if so, does anyone know the cause?
I have 8 gigs of RAM BTW.
Thanks