markz528
Hot Rolled
- Joined
- Sep 25, 2012
- Location
- Cincinnati
I'm just learning how to digitize with my Centroid M400 control. I use AutoCad 2010 Mechanical 2D. I am not familiar with Cam programs at this time - still learning. I am on the low end of competent with AutoCad 2010 Mechanical - don't know much about the advanced features.
I do have a copy of 2008 MasterCam that I have never used. Can that help me?
I've got a job that I need to digitize. I ran a test part and cannot figure out how to get it into AutoCad.
Centroid saves the digitized file as a .cam extension. When I export it, I expected a .dig file but instead it saved it as a .txt file (see below). Its not a .csv file, but a text file - looks like x, y and z values. Honestly not sure what I would have done with the .dig file either.
Can anyone point me in the right direction to get the digitized file into AutoCad 2010?
I do have a copy of 2008 MasterCam that I have never used. Can that help me?
I've got a job that I need to digitize. I ran a test part and cannot figure out how to get it into AutoCad.
Centroid saves the digitized file as a .cam extension. When I export it, I expected a .dig file but instead it saved it as a .txt file (see below). Its not a .csv file, but a text file - looks like x, y and z values. Honestly not sure what I would have done with the .dig file either.
Can anyone point me in the right direction to get the digitized file into AutoCad 2010?