There is an issue with cutting path extended outside of the part in NX CAM. Can anyone enlighten me on how to optimize the path. I was hoping that the cutting tool retract straight after cutting finish the part, instead of it extend outside of the part.
There is an issue with cutting path extended outside of the part in NX CAM. Can anyone enlighten me on how to optimize the path. I was hoping that the cutting tool retract straight after cutting finish the part, instead of it extend outside of the part.
You did not mention the type of operation you are using. There are toolpath extension options for pretty much all of the 3-5 axis operations and the boundary driven path have some options too. In general, aside from the cutting extensions you control engage/retract in Non Cutting Moves. That is where you can fully control engage, retracts, transfers, smoothing, start points and more.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.