Fully Defined
Aluminum
- Joined
- Oct 12, 2013
- Location
- San Francisco, CA
Can someone give me some advice on how to force SWCAM to make this toolpath a spiral?
I am having some trouble getting a spiral toolpath for counterboring some holes. At one point, I was able to get a spiral toolpath, but it was in addition to what you see in the attached image, not replacing it. That took a lot of clicking, so I am not even sure how I did it anymore.
I am using a 6.35mm end mill on a 20x40 VMC with a Mitsubishi M64s control.
I am having some trouble getting a spiral toolpath for counterboring some holes. At one point, I was able to get a spiral toolpath, but it was in addition to what you see in the attached image, not replacing it. That took a lot of clicking, so I am not even sure how I did it anymore.
I am using a 6.35mm end mill on a 20x40 VMC with a Mitsubishi M64s control.
Last edited: