Bobnotthecat
Cast Iron
- Joined
- Jul 5, 2009
- Location
- S.W. PA
Sirs
I'm an older, old school manual machinist and bought this software because that's what I could afford and was conveniently available at my local office supply. I wasn't looking for anything to sophisticated, just something to use for simple shop drawings. I'm hoping yunz could help me with my questions. I cannot always find my answers in their tutorials or u-tube videos or in the manual that came with the program.
If anyone could help, my first question is:
While using the cadware one day I accidentally ran across what we use to call a "title strip" template. Cannot for the life of me find it again. Any advice/clues would be most welcome.
Thanks for looking,
Bob....not the cat.
I'm an older, old school manual machinist and bought this software because that's what I could afford and was conveniently available at my local office supply. I wasn't looking for anything to sophisticated, just something to use for simple shop drawings. I'm hoping yunz could help me with my questions. I cannot always find my answers in their tutorials or u-tube videos or in the manual that came with the program.
If anyone could help, my first question is:
While using the cadware one day I accidentally ran across what we use to call a "title strip" template. Cannot for the life of me find it again. Any advice/clues would be most welcome.
Thanks for looking,
Bob....not the cat.
Last edited:
