What's new
What's new

Cincinatt Arrow 750 - Spindle alignment - Motionlink software

Burf86

Plastic
Joined
May 10, 2021
Hi All,
I recently had the spindle drive repaired on my Cincinnati Arrow 750, Acramatic A2100 Control, Kollmorgen drives.

The spindle seems to align correctly during the initial homing of the machine, but when I go make a tool change it comes up with Alarm 39-92

Remedy: Correct device status:-
Input CR_OR_COMP ON
Either Output CR_SPDL_ORN ON or Output CR_SPDL_ORN2 ON
(NOT both together) CR_SPDL_ORN2 is for orientation to optional 2nd drum on a Sabre machine only.
Check spindle drive setup. Adjust any drift in the system

I have looked around for spindle alignment forum posts and most say I would need motionlink software, an old computer, and a link to the spindle drive in order to adjust some settings in there. Or to fiddle with the belts...

I have found the software I need for my drives; Motionlink Plus BDS5 VFS5 software . exe but I have been unable to find much information on how to use it and the most recent forum post I can find on the stuff is 2017.

Any handy tricks and tips?
 








 
Back
Top