So a few weeks ago a Cincinnati 2ML followed me home mere steps ahead of a trip to the scrapper.
I've been doing some general cleaning and taking care of some issues I've found. One of those issues was a broken stud on the vertical head. I have pulled the head off (where it angles down in the picture) but there is no obvious way to get the ring which retains the studs off.
While I have the service manual for the 2ML mill, it makes no reference to the vertical head. Which means I have no drawings showing how deeply I need to dig in to get this repaired.
I would be extremely grateful for any help that could be provided.
I've been doing some general cleaning and taking care of some issues I've found. One of those issues was a broken stud on the vertical head. I have pulled the head off (where it angles down in the picture) but there is no obvious way to get the ring which retains the studs off.
While I have the service manual for the 2ML mill, it makes no reference to the vertical head. Which means I have no drawings showing how deeply I need to dig in to get this repaired.
I would be extremely grateful for any help that could be provided.