CraigsList Peoria: K&T Vertical Head for 3-5/8" Overarms

Don Kinzer · Oct 30, 2020

I found this while searching for a vertical head for my 2CHL. The seller describes it as fitting K&T machines with 3-5/8" overarms but doesn't mention the overarm spacing. It looks like there is an unmounted drive gear - who knows if it is actually for that head. At $500 though, someone is probably going to get a reasonable deal.

milling machine vertical head and 2 outboard supports - tools - by...

Rob F. · Oct 30, 2020

Text of add:

milling machine vertical head and 2 outboard supports - $500

Virtical head and 2 outboard supports fits Kerney and trekker milwaukee
Horizontal milling machine with 3 5/8
Overhead shafts.

Don Kinzer · Oct 30, 2020

I just realized that the gear in the photo is straight cut. All of the other drive gears for vertical heads that I've seen are helical. It may not be for that head at all.

johnoder · Oct 31, 2020

2H and 2CH. (?) Never had straight cut gears to drive with. Unit will have a raised machined pad with serial and lot number stamped therein - will give age

On Edit:

'17 catalog neglects to comment on over arm dimensions

2H and 2CH will be 8.375" out to out on overarms

I agree head appears to be from that period - and if so it will be plain bearing

Double over arms were patented in 1913, so it could be nearly that old

woodsrider845 · Oct 31, 2020

Been looking for one for a while. Thanks!

While I'm waiting to hear back from them, Anyone have the drive gear, if I end up getting this, and need it?

Ohio Mike · Oct 31, 2020

If the head and overarms came from the same machine which I think they did then this came off an older machine like a 2B or 3B. Notice the clamping method on the overarm. No clue if the dimensions are the same as the "modern" machine that were produced starting in the mid 30s.

ramsay1 · Oct 31, 2020

Looks like a unit from a much earlier machine if those arbor supports are any indication... May be drive gear for unit but later ones definitely had helical gears.....Kearney & Trecker Co. - Publication Reprints - Attachments for Milwaukee Milling Machines - Catalog | VintageMachinery.org As mentioned earlier, there should be a number stamped on the unit.. Cheers; Ramsay 1

Search

Largest Manufacturing Technology Community on the Web

Search

CraigsList Peoria: K&T Vertical Head for 3-5/8" Overarms

Don Kinzer

Cast Iron

Rob F.

Diamond

Don Kinzer

Cast Iron

johnoder

Diamond

woodsrider845

Hot Rolled

Ohio Mike

Titanium

ramsay1

Titanium

Similar threads