jakefreese
Hot Rolled
- Joined
- Aug 4, 2012
- Location
- TEXAS
It appears that thanks to some oil sludge that plugged up my oil port to the spindle bearing it is now trashed. 2-3 thou of movement...... The spindle has never really been quiet on this machine, but still had good surface finish until about a week ago.
I'll get pictures in a bit. I have loosened the collar for spindle preload, loosened the intermediate bearing collar off removed both end plates ( at chuck and opposite drive side). It appears to me it should come out. What is the preferred method of removal? Puller? Slide hammer? I'm planning on new bearings on the whole shaft.
Thanks!
Sent from my XT1650 using Tapatalk
I'll get pictures in a bit. I have loosened the collar for spindle preload, loosened the intermediate bearing collar off removed both end plates ( at chuck and opposite drive side). It appears to me it should come out. What is the preferred method of removal? Puller? Slide hammer? I'm planning on new bearings on the whole shaft.
Thanks!
Sent from my XT1650 using Tapatalk