Hi,
If this is the wrong subforum, please lemme know, or move this, or whatever is appropriate.
I recently moved in a Gorton 1-22 MasterMill.
It's got a NMTB 40 taper.
The Spindle bore is too small (about .6") to accept a 5/8" drawbar.
Not so much looking for solutions (although great ideas are always appreciated).
More looking for confirmation that this came from the factory like this? Or is this a retrofit?
How far out does your spindle nose stick from the quill?
How does the drawbar in your Gorton 1-22 Mastermill work?
Thanks!
If this is the wrong subforum, please lemme know, or move this, or whatever is appropriate.
I recently moved in a Gorton 1-22 MasterMill.
It's got a NMTB 40 taper.
The Spindle bore is too small (about .6") to accept a 5/8" drawbar.
Not so much looking for solutions (although great ideas are always appreciated).
More looking for confirmation that this came from the factory like this? Or is this a retrofit?
How far out does your spindle nose stick from the quill?
How does the drawbar in your Gorton 1-22 Mastermill work?
Thanks!