7sharpshooter
Plastic
- Joined
- Jul 10, 2016
Picked up a VN 1RQ-3-22 with a 2 axis dro, VN horizontal dividing head for a decent price and going through it found that the table feed motor is gone. The motor plate is on the knee and it is a 1/3 hp 3 phase 1725 rpm but I don't know the pulley diameter and was hoping someone here might know or have a reference somewhere. I checked the yahoo group but there is not much there on the 1rq. Also, any general advice for cleaning up this mill is appreciated. I have a clausing 13 x 36 lathe, a millrite mill, B&S 618 micromaster, jeol scanning electron microscope, 1920's huge screw press, and an 88 lbs self contained pneumatic forging hammer to play with and which I will use to make a rough forging of the overarm support for the 1rq.