I fussed around aligning the new to me 4th axis on my Fadal, setting the offset and then realized the servo would come blowing through the door glass on max Y positive. I have about another .250” of +Y when the end of the servo hits the door window.
I tried moving the axis to the rear slot but it hits the Z ways with minus .3” travel left.
So... I either need to move my cold start or remember to open the door
Anyone see this before. My Y axis CS position indicator does seem to be maxed out to the front, so there is probably a .250 adjustment.
Any issue with moving the cold start 1/4”?
Thanks
Sent from my iPhone using Tapatalk Pro
I tried moving the axis to the rear slot but it hits the Z ways with minus .3” travel left.
So... I either need to move my cold start or remember to open the door
Anyone see this before. My Y axis CS position indicator does seem to be maxed out to the front, so there is probably a .250 adjustment.
Any issue with moving the cold start 1/4”?
Thanks
Sent from my iPhone using Tapatalk Pro