Coolant is qualichem 250 at 7%.
Coolant is on full blast during machining and machine warm up.
Material is 5051.
After machining these sheet metal parts, I grab the wash down gun and started to clean off the covers, machine etc.
Chips were stuck as the wash down gun wasn't moving them off the covers. I had to take my hand and wipe down the waycovers in order to get the wash down gun to be effective.
Had this happen years ago but it was because my coolant go up close to 10.5-11%. This time, I'm at min of concentration 7%. Machine is Haas vf2ss 2020 year.
Coolant is on full blast during machining and machine warm up.
Material is 5051.
After machining these sheet metal parts, I grab the wash down gun and started to clean off the covers, machine etc.
Chips were stuck as the wash down gun wasn't moving them off the covers. I had to take my hand and wipe down the waycovers in order to get the wash down gun to be effective.
Had this happen years ago but it was because my coolant go up close to 10.5-11%. This time, I'm at min of concentration 7%. Machine is Haas vf2ss 2020 year.