Terminal_Crazy
Plastic
- Joined
- Aug 17, 2016
Good evening.
I'd like to ask if anyone can point me in the right direction please.
I have an old King Rich KRV-3000 3 axis milling machine running Anilam 1100M software.
I've just replaced the battery on the main board as the mill had been sitting for a while.
I've also replaced the SSR K2 on the 801 board as I heard a loud pop when the machine was switched on.
The anilam software seems to boot up ok.
When I release the stop button and reset the servos, the machine traverses X or Y until the max travel safety switch is pressed which immediately cuts the servos off.
I presume I'm right on the understanding that I've lost any saved settings for this machine.
I DO NOT have a diagnostics disk with this machine.
I'm fairly certain the floppy does NOT work either, but I've not fully investigated yet. I've never used it.
I've always used the machine by uploading the programs over serial link.
Anyone able to point the way please.
Thanks
Mitchell D. Crawford
I'd like to ask if anyone can point me in the right direction please.
I have an old King Rich KRV-3000 3 axis milling machine running Anilam 1100M software.
I've just replaced the battery on the main board as the mill had been sitting for a while.
I've also replaced the SSR K2 on the 801 board as I heard a loud pop when the machine was switched on.
The anilam software seems to boot up ok.
When I release the stop button and reset the servos, the machine traverses X or Y until the max travel safety switch is pressed which immediately cuts the servos off.
I presume I'm right on the understanding that I've lost any saved settings for this machine.
I DO NOT have a diagnostics disk with this machine.
I'm fairly certain the floppy does NOT work either, but I've not fully investigated yet. I've never used it.
I've always used the machine by uploading the programs over serial link.
Anyone able to point the way please.
Thanks
Mitchell D. Crawford