M. Moore
Titanium
- Joined
- Jun 8, 2007
- Location
- Vancouver Island, B.C. Canada
Totally new to CNC.
Just learning my machine and it has an Anilam 3000 3 axis control on a vertical mill.
I have been testing out some canned cycles and it is fairly straightforward to input the info, getting the info correct is not so easy.
The question is can I edit a canned program after writing it? In particular if I input the data and then run a test and something is not quite right (Z to low etc) I have to input all the info again. Is there a way to fill out the canned cycle page with the existing program info? Or a copy and paste kind of thing?
I have the manual and can’t seem to find anything that helps with this problem quite yet anyway.
I have lots of other questions but this would get me going faster on running test programs to learn.
Thanks
Michael
Just learning my machine and it has an Anilam 3000 3 axis control on a vertical mill.
I have been testing out some canned cycles and it is fairly straightforward to input the info, getting the info correct is not so easy.
The question is can I edit a canned program after writing it? In particular if I input the data and then run a test and something is not quite right (Z to low etc) I have to input all the info again. Is there a way to fill out the canned cycle page with the existing program info? Or a copy and paste kind of thing?
I have the manual and can’t seem to find anything that helps with this problem quite yet anyway.
I have lots of other questions but this would get me going faster on running test programs to learn.
Thanks
Michael