Is anyone using the twin delta pallet system offered by Orange Vise? I don't know too much about it and haven't really seen anything on youtube about it. I like the idea that there are no pins to locate the pallets so it should be effortless to swap. It looks like the total cost is somewhere in the neighborhood of $1200 for the 6x17.5 vise and a set of master jaws which seems reasonable.
There are a few things I don't understand about it if anyone can shed some light:
Is there a standard point you would choose for your work offset on this system? I assume on the master jaws, the fixed jaw is pinned, so my guess is a good place would be the front point of the V for X0Y0 and the first level in front of the dovetail for Z0. Is that correct?
Is it fair to say that the big advantage of this system is that you can switch from using it as a pallet system to a vise without indicating anything?
I'd appreciate any thoughts.
There are a few things I don't understand about it if anyone can shed some light:
Is there a standard point you would choose for your work offset on this system? I assume on the master jaws, the fixed jaw is pinned, so my guess is a good place would be the front point of the V for X0Y0 and the first level in front of the dovetail for Z0. Is that correct?
Is it fair to say that the big advantage of this system is that you can switch from using it as a pallet system to a vise without indicating anything?
I'd appreciate any thoughts.