martin_05
Hot Rolled
- Joined
- Mar 11, 2009
- Location
- Valencia, CA, USA
Big Kaiser has them (expensive):
Chip Fan | BIG KAISER
And there are others, going down to so cheap they must be dangerous:
Error 400 (Bad Request)!!1
https://www.redlinetools.com/itemde...3bQjvKfjCHm5Sw2ZhCIlOLew6El1YxoCRwMQAvD_ BwE
...and a video:
I have RC airplanes with folding carbon fiber propellers as large in diameter as 14 inches. They move a ton of air and can handle the RPM's just fine. However, they are not struck by chips in flight, which could happen to these CNC versions I suppose. That's where the $40 version becomes scary.
Maybe they save time and mess? you do lose one slot in the tool changer.
Any thoughts? Worth it?
Chip Fan | BIG KAISER
And there are others, going down to so cheap they must be dangerous:
Error 400 (Bad Request)!!1
https://www.redlinetools.com/itemde...3bQjvKfjCHm5Sw2ZhCIlOLew6El1YxoCRwMQAvD_ BwE
...and a video:
I have RC airplanes with folding carbon fiber propellers as large in diameter as 14 inches. They move a ton of air and can handle the RPM's just fine. However, they are not struck by chips in flight, which could happen to these CNC versions I suppose. That's where the $40 version becomes scary.
Maybe they save time and mess? you do lose one slot in the tool changer.
Any thoughts? Worth it?