BugRobotics
Stainless
- Joined
- Jun 22, 2015
- Location
- Denver, CO
Hi all,
Been modifying stock male to female aluminum M3 and M2.5 hex standoffs (4.5mm hex) to length (12.2mm and 39mm lengths) and re-drilling/tapping for a client with a small run operation for a few years. They would like to quote the parts from bar stock. Let's say qty 100, 250 and 500. Any guesses?
I'd guess it will be hard to beat the cost of the common sizes that I can buy now at $0.40 and put about a minute each into them to get them to the spec but who knows...hopefully someone out there. Thanks!
Been modifying stock male to female aluminum M3 and M2.5 hex standoffs (4.5mm hex) to length (12.2mm and 39mm lengths) and re-drilling/tapping for a client with a small run operation for a few years. They would like to quote the parts from bar stock. Let's say qty 100, 250 and 500. Any guesses?
I'd guess it will be hard to beat the cost of the common sizes that I can buy now at $0.40 and put about a minute each into them to get them to the spec but who knows...hopefully someone out there. Thanks!