Hello everyone,
I just wanted to know if anyone has the electrical schematic for the Summit/Dana Bandit controller on a Shizouka AN-S CNC knee mill. This machine is from the 1979-1980.
The sticker on the bandit controller has the following information.
Model No.: 21-300-33 ?
Serial No.: 803445
115 VAC, 60 HZ
I’m not sure if these numbers are correct as they are very hard to see
See attached photos
Currently, when I turn on the controller the following lights turn on.
1. Contouring Entry
2. -DN
3. /Shift
4. Reload
Please see attached photo.
At the same time the X and Y-axis motors shake rapidly back and forth.
Any help would be appreciated.
Thank you,
Don
I just wanted to know if anyone has the electrical schematic for the Summit/Dana Bandit controller on a Shizouka AN-S CNC knee mill. This machine is from the 1979-1980.
The sticker on the bandit controller has the following information.
Model No.: 21-300-33 ?
Serial No.: 803445
115 VAC, 60 HZ
I’m not sure if these numbers are correct as they are very hard to see
See attached photos
Currently, when I turn on the controller the following lights turn on.
1. Contouring Entry
2. -DN
3. /Shift
4. Reload
Please see attached photo.
At the same time the X and Y-axis motors shake rapidly back and forth.
Any help would be appreciated.
Thank you,
Don