Hello,
HELP...
I have attached a rough sketch detailing my attempts to align the head stock to the tail stock on our BP/Romi 20" x 60" Lathe
Sketch #3 is a 16" long 1.250 TGP shaft, center drilled on both ends. The shaft was indicated to 0.0005" before centers were drilled.
Based on this test I thought everything should be good. But this proved different in sketch #1 and #2.
So I'm chasing my tail....any help would be greatly appreciated.
Larry
HELP...
I have attached a rough sketch detailing my attempts to align the head stock to the tail stock on our BP/Romi 20" x 60" Lathe
Sketch #3 is a 16" long 1.250 TGP shaft, center drilled on both ends. The shaft was indicated to 0.0005" before centers were drilled.
Based on this test I thought everything should be good. But this proved different in sketch #1 and #2.
So I'm chasing my tail....any help would be greatly appreciated.
Larry