Discrepancyform
Plastic
- Joined
- Aug 8, 2017
So I’m running a vbm with live tooling and we’ve managed to thread mill point to point with it and I’ve also written full circle interpolations long hand but when I try and long hand a thread mill I get “illegal plane select”
Code is something like
X(center of hole)
Z(depth)
G17
G1 X(start point)
G2 x k j z (this is where it alarms and if I remove the z it will run just fine except I would just have 13 grooves per inch obviously)
I was not running with polar interpolation on which I will try tomorrow but it seems like I shouldn’t need to and either the machine or I is missing something.
Any tips?
Thanks.
Code is something like
X(center of hole)
Z(depth)
G17
G1 X(start point)
G2 x k j z (this is where it alarms and if I remove the z it will run just fine except I would just have 13 grooves per inch obviously)
I was not running with polar interpolation on which I will try tomorrow but it seems like I shouldn’t need to and either the machine or I is missing something.
Any tips?
Thanks.