Cooperstock
Aluminum
- Joined
- Apr 13, 2015
Hello,
I have a matsuura MC760
I just reconnected the coolant system after transport. I put enough fluid to cover the end of the inlet of the pump. I run M8 and I can hear the pump turn on but I don't get any fluid out of the nozzles at the cutter.
There are on/off valves at the flex tube at the cutters, those are on.
Is there something else that needs to be 'active' to allow coolant to get to the nozzle?
Do I need to perform some sort of bleeding/priming of the pump?
I tried to reverse two of the phases to see if it was spinning backwards, no change.
Any thoughts?
Thanks
David
I have a matsuura MC760
I just reconnected the coolant system after transport. I put enough fluid to cover the end of the inlet of the pump. I run M8 and I can hear the pump turn on but I don't get any fluid out of the nozzles at the cutter.
There are on/off valves at the flex tube at the cutters, those are on.
Is there something else that needs to be 'active' to allow coolant to get to the nozzle?
Do I need to perform some sort of bleeding/priming of the pump?
I tried to reverse two of the phases to see if it was spinning backwards, no change.
Any thoughts?
Thanks
David