markp
Hot Rolled
- Joined
- Oct 7, 2006
- Location
- Petaluma CA 94952
DMU50V Spindle error S173+
I have a 2000 DMU50V with millplus control. Was doing a sort of long (6hours) surfacing job today at 8k rpm and the spindle started making a buzzing noise. Its done this before after a few hours at higher speeds but surface finish is good so Ive ignored it. Today the spindle stopped with a "S173+" error. It slowly spun down and stopped. While slowing it did not respond to any spindle commands. I opened the back cabinet and the spindle drive is in "ready" mode.
I could not clear the error so I restarted. Now when ever a command is issued to the spindle, (including a tool change, same tool is still in spindle)it gives the same error. I spun the spindle by hand and it seems smooth. Anyone know what it might be?
I have a 2000 DMU50V with millplus control. Was doing a sort of long (6hours) surfacing job today at 8k rpm and the spindle started making a buzzing noise. Its done this before after a few hours at higher speeds but surface finish is good so Ive ignored it. Today the spindle stopped with a "S173+" error. It slowly spun down and stopped. While slowing it did not respond to any spindle commands. I opened the back cabinet and the spindle drive is in "ready" mode.
I could not clear the error so I restarted. Now when ever a command is issued to the spindle, (including a tool change, same tool is still in spindle)it gives the same error. I spun the spindle by hand and it seems smooth. Anyone know what it might be?