Okay, so we're three weeks into this machine being down. It is a Doosan HP4000 Horizontal with a 31i control.
Long story short, it has had spindle rotor, spindle amplifier, and speed sensor installed. spindle runs quietly, it is tracking spindle speed when commanded, however when M19 is called it kicks "SP9082 (S) No 1 Rot Motor sensor". It's obviously working if it is showing speed. Cable form the sensor to amplifier is fine, we've even swapped back between old and new, same alarm. We did have to reload a backup of the control early on, is there possibly some parameter we're missing here.
Any help would be much appreciated. Thanks in advance.
Long story short, it has had spindle rotor, spindle amplifier, and speed sensor installed. spindle runs quietly, it is tracking spindle speed when commanded, however when M19 is called it kicks "SP9082 (S) No 1 Rot Motor sensor". It's obviously working if it is showing speed. Cable form the sensor to amplifier is fine, we've even swapped back between old and new, same alarm. We did have to reload a backup of the control early on, is there possibly some parameter we're missing here.
Any help would be much appreciated. Thanks in advance.