chip_maker
Stainless
- Joined
- Jan 14, 2006
- Location
- Moira, NY USA
When I use the toolsetter on my lynx 220lmsa all of the tools on the main spindle are off approximately .160 in the z+. Everything on the sub side is fine.
How do I get the toolsetter to zero the tools on the face of the part instead of .160 in front of it? is there a parameter or some registry I need to put an offset in or something?
Thanks
How do I get the toolsetter to zero the tools on the face of the part instead of .160 in front of it? is there a parameter or some registry I need to put an offset in or something?
Thanks