Hello
Im new to the forum and have a question for the Doosan lathe gurus here. I am programming a Puma 2600 SYII (fanuc controller)to use the subspindle as a tailstock. I turned a dead center and have it clamped in the subspindle. I have had great success with it so far but had a question about how much thrust this dead center is putting on my part.
My program is basic and I am using a G300 command to advance the dead center into the part. After all machining, I am using a G301 to cancel the torque control command.
My question is how can I adjust the amount of pressure put on the part?
Thanks in advance!
Im new to the forum and have a question for the Doosan lathe gurus here. I am programming a Puma 2600 SYII (fanuc controller)to use the subspindle as a tailstock. I turned a dead center and have it clamped in the subspindle. I have had great success with it so far but had a question about how much thrust this dead center is putting on my part.
My program is basic and I am using a G300 command to advance the dead center into the part. After all machining, I am using a G301 to cancel the torque control command.
My question is how can I adjust the amount of pressure put on the part?
Thanks in advance!
Last edited:
