nightsky84
Aluminum
- Joined
- Nov 26, 2019
So we just had an LNS quick 6 bar feeder installed. He gave me some sample programs for the barfeeder to go off of which I used for the most part. M50 and M51 are bar feeder codes for this machine. He said I should only have to use M51. I tried that it didn't work. So I thought well I'll try to use both. It worked! Awesome right? Well it goes through the cycle perfectly from the start and then starts over on the next piece. Well the stop comes out and the collet opens and the barfeeder pushes it maybe an inch if that and it just stops. Nothing happens until I have to reset the machine cause it's just sitting there. So I'm attaching all of my files for this program and would like some support whether it be the barfeed part of the program or even check my sub program to see if that would make the barfeed switch out bars properly. I have never messed with a barfeeder before so this is all new to me but I'm trying my best! Thanks in advance!!View attachment O9999.txtView attachment O0310.txtView attachment O0311.txt