Hello,
I plan to drill Thru. hole on OD 6" material 4140
However, in the radial tool holder 6" drill can not be mounted due to length
what if us 3" drill and using C axis 0deg to 3" depth then run C180 to drill 3"
is there any problem? will drill miss alignment?
Thanks
I plan to drill Thru. hole on OD 6" material 4140
However, in the radial tool holder 6" drill can not be mounted due to length
what if us 3" drill and using C axis 0deg to 3" depth then run C180 to drill 3"
is there any problem? will drill miss alignment?
Thanks