Cole2534
Diamond
- Joined
- Sep 10, 2010
- Location
- Oklahoma City, OK
I'm dead to rights new to 3d CNC, and this one issue is kicking my butt.
I've reinitialized the machine, so there's no leftover offsets that I'm aware of, I've set the tools and fixture offsets appropriately (I think), but I can't stop the machine from homing to an obscure Z position before rapiding up to the R plane.
I'm using Fusion 360 with a good post, provided by a reputable source.
If I set the tool offset really high, as in above TC height, I can watch the motion without dinging the table or vise and it routinely does the same motion. Below is a snippet of the code, what am I missing?
%
O1001
(T1 D=0.25 CR=0. - ZMIN=-0.25 - FLAT END MILL - 1/4" FLAT ENDMILL)
N10G0G17G40G80G90
N15G0H0Z0.
(FACE2)
N20G9
N25M5M6T1(1/4" Flat Endmill)
N30M3S3500
N35E1
N40X1.6625Y-0.9002
N45H1Z0.6M7
N50G4P2000
N55Z0.2
N60G1Z0.025F60.
N65G18G3X1.6375Z0.I-0.025
N70G1X1.5
N75X-1.5F31.5
N80G17G2Y-0.6778J0.1112
N85G1X1.5
N90G3Y-0.4555J0.1112
N95G1X-1.5
I've reinitialized the machine, so there's no leftover offsets that I'm aware of, I've set the tools and fixture offsets appropriately (I think), but I can't stop the machine from homing to an obscure Z position before rapiding up to the R plane.
I'm using Fusion 360 with a good post, provided by a reputable source.
If I set the tool offset really high, as in above TC height, I can watch the motion without dinging the table or vise and it routinely does the same motion. Below is a snippet of the code, what am I missing?
%
O1001
(T1 D=0.25 CR=0. - ZMIN=-0.25 - FLAT END MILL - 1/4" FLAT ENDMILL)
N10G0G17G40G80G90
N15G0H0Z0.
(FACE2)
N20G9
N25M5M6T1(1/4" Flat Endmill)
N30M3S3500
N35E1
N40X1.6625Y-0.9002
N45H1Z0.6M7
N50G4P2000
N55Z0.2
N60G1Z0.025F60.
N65G18G3X1.6375Z0.I-0.025
N70G1X1.5
N75X-1.5F31.5
N80G17G2Y-0.6778J0.1112
N85G1X1.5
N90G3Y-0.4555J0.1112
N95G1X-1.5