isaac338
Cast Iron
- Joined
- Sep 25, 2008
- Location
- Halifax, Canada
I have a Mori Seiki SL3 lathe with a Fanuc 11 control. I was running a bunch of parts today and in the middle of a cut the control shut off completely, like if someone pressed the "off" button.
If you press "on" the MCC pulls in but there's no display on the CRT. The master board LCD reads 8 but is blinking very rapidly.
Any ideas? I'm thinking a power unit that's shorted or dead - the blinking LCD makes it seem like it's powering up the master board and then immediately dying over and over.
If you press "on" the MCC pulls in but there's no display on the CRT. The master board LCD reads 8 but is blinking very rapidly.
Any ideas? I'm thinking a power unit that's shorted or dead - the blinking LCD makes it seem like it's powering up the master board and then immediately dying over and over.