Davefurney
Plastic
- Joined
- Oct 7, 2019
Just hoping someone can help. I bought an older lathe.
It’s got a Fanuc 3T on a Nakamura Tome 2 axis.
Everything functions normally. Can run a program from start to finish, simple drill and part off program, on completion of program, it returns to top of program and appears to wait for next cycle start signal.
Then press cycle start to repeat the program and it gives a 059 alarm.
So, I go to MDI , input a GO Z350.0, cycle start and the turret moves to Z350.0
Go back to auto, press cycle start and it runs through the entire program and back to the top of the program.
Then press cycle start to run again and same 059 alarm comes up ???
It doesn’t let me just keep pressing cycle start to run a program repeatedly?
Anyone know what’s up with this thing?
Thanks a million
Dave
It’s got a Fanuc 3T on a Nakamura Tome 2 axis.
Everything functions normally. Can run a program from start to finish, simple drill and part off program, on completion of program, it returns to top of program and appears to wait for next cycle start signal.
Then press cycle start to repeat the program and it gives a 059 alarm.
So, I go to MDI , input a GO Z350.0, cycle start and the turret moves to Z350.0
Go back to auto, press cycle start and it runs through the entire program and back to the top of the program.
Then press cycle start to run again and same 059 alarm comes up ???
It doesn’t let me just keep pressing cycle start to run a program repeatedly?
Anyone know what’s up with this thing?
Thanks a million
Dave