haastec
Hot Rolled
- Joined
- Mar 8, 2010
- Location
- Southwest, USA
A couple times now I have had the alarms 1019 Spindle Defective along with 9083 SPN:S-SPINDLE ERROR (AL-083). Both times I was able to cycle power and was able to continue running. Alarms happened about 3 weeks apart. Now I am getting a 453 Z-AXIS: SPC SOFT DISCONNECT ALARM. This alarm does not clear and returns at power on.
Both of the alarm conditions appear to be encoder related, but I have a hard time believing that the Z-Axis motor and Spindle motor both suddenly have bad encoders. I have double checked the cable connections and they are tight and clean. When the 1019/9083 alarms happened, I neglected to see if the sp drive showed any alarms, but for the 453 alarm it only shows a dash (-).
Can anyone point me in a direction for things to check? Not a whole lot of experience troubleshooting the Robo's.
Thanks!
Both of the alarm conditions appear to be encoder related, but I have a hard time believing that the Z-Axis motor and Spindle motor both suddenly have bad encoders. I have double checked the cable connections and they are tight and clean. When the 1019/9083 alarms happened, I neglected to see if the sp drive showed any alarms, but for the 453 alarm it only shows a dash (-).
Can anyone point me in a direction for things to check? Not a whole lot of experience troubleshooting the Robo's.
Thanks!