Rick Finsta
Stainless
- Joined
- Sep 27, 2017
I'm not sure what parameter I'm looking for, or if this can be changed, but when I input a program on my OT-A I have line numbers with macro error calls after the M30 (this is just the way I was taught to do it, if there is a better way I'm all ears). Anyways, the control automatically puts any lines after an M30 into a new program, numbered sequentially one greater than the program number I'm inputting.
So I input O0875, it creates O0875 with my code up to the M30, and then creates O0876 with the lines after the M30.
Is there a way to change this behavior so it will keep the macro error calls in the same program?
Otherwise I will change over and have them before the M30 but with GOTO logic that will skip them unless they have been called specifically by line number.
Thanks!
So I input O0875, it creates O0875 with my code up to the M30, and then creates O0876 with the lines after the M30.
Is there a way to change this behavior so it will keep the macro error calls in the same program?
Otherwise I will change over and have them before the M30 but with GOTO logic that will skip them unless they have been called specifically by line number.
Thanks!