DeSelle
Cast Iron
- Joined
- Oct 23, 2006
- Location
- Midlothian, TX
Hi all,
Trying to run off a couple of pipe half nipples for a job and I'm having an issue with G76 lines
I'm shooting for 6" NPT
G00 X6.625 Z-1.750 (start point)
G76 P010060 Q050 R.002
G76 X6.425 Z0.0 R.0545 P1000 Q020 F.125
It appears to be close but it does a little dance at the relief groove where I start and at the end.
I am not sure I fully understand the G76 command. I'm running a Doosan Puma 400LB slant bed. The control is an I series 2008.
Since the tool is in the back and facing up don't I have to feed from Z neg to pos for RH thread?
Any help is appreciated
Nathan
Trying to run off a couple of pipe half nipples for a job and I'm having an issue with G76 lines
I'm shooting for 6" NPT
G00 X6.625 Z-1.750 (start point)
G76 P010060 Q050 R.002
G76 X6.425 Z0.0 R.0545 P1000 Q020 F.125
It appears to be close but it does a little dance at the relief groove where I start and at the end.
I am not sure I fully understand the G76 command. I'm running a Doosan Puma 400LB slant bed. The control is an I series 2008.
Since the tool is in the back and facing up don't I have to feed from Z neg to pos for RH thread?
Any help is appreciated
Nathan