Gents;
I just completed an overhaul on a Johnford SV-35. New turcite, new bearings...etc. the control Han had no power to it for 3 months or so. At any rate when I powered up the machine it comes on but will not enable. I get a flash of light across the control panel but the machine won't stay on. I also get a red light on what I think is the power supply. The light indicates CP4. It is directly below the battery. Any thoughts or help would bring appreciated.
Thanks
Fred T
I just completed an overhaul on a Johnford SV-35. New turcite, new bearings...etc. the control Han had no power to it for 3 months or so. At any rate when I powered up the machine it comes on but will not enable. I get a flash of light across the control panel but the machine won't stay on. I also get a red light on what I think is the power supply. The light indicates CP4. It is directly below the battery. Any thoughts or help would bring appreciated.
Thanks
Fred T