MwTech Inc
Titanium
- Joined
- Feb 6, 2005
- Location
- Fishersville VA
Anyone here know the specifics on moving this mill?
I do have all the books...........
Hitachi simply says to "lower and block the head" and to "clamp the tool unclamping cylinder" . (two bolts)
Not sure if the head has to be "down" to do these bolts or not..?.. (unit not hooked up to power, yea I know, the whole parameter thing, battery thing, have the parameters)
The head is up, can one manually reach-in somewhere and turn the screw?
Is there some sort of counterweight that balances the head??
Don't want to go down the road bouncing the head on the ball screw
Rest of the instructions are simple are far as locking the x/y movement.
I do have all the books...........
Hitachi simply says to "lower and block the head" and to "clamp the tool unclamping cylinder" . (two bolts)
Not sure if the head has to be "down" to do these bolts or not..?.. (unit not hooked up to power, yea I know, the whole parameter thing, battery thing, have the parameters)
The head is up, can one manually reach-in somewhere and turn the screw?
Is there some sort of counterweight that balances the head??
Don't want to go down the road bouncing the head on the ball screw
Rest of the instructions are simple are far as locking the x/y movement.