What's new
What's new

Lathe Drill and Tap

ljeremy578

Plastic
Joined
Aug 6, 2018
I have a hole to drill on the Z and then a hole to drill and tap on the Y. Is there any way to get away from leaving a burr if drill and tap the hole on the Y last? 304 Stainless is the material and tapped hole is 1/4-20. The other whole is .531"
 
What type of material, what size is the thread? You need to provide more information.
 
Can you post a print or a picture of the part?

IDK, some customers are fussy about that kind of thing......:D

It will make a difference if the holes are similar in diameter or one is way bigger, etc.
 








 
Back
Top